Rock-slide-engineering JK4 SLIDER Manual do Utilizador descarregar pdf

Installation Instruction RSEI 109

JK4 SLIDER INSTALLATION

SL-4D-100-JK

SLIDER INSTALLATION

1. Remove the stock rocker guards if equipped

2. Remove the front body bolts on the driver and passenger side (under the front

door)

3. Loosen the rear body bolts (under rear passenger doors)

a. DO NOT REMOVE THESE BOLTS! You will need these bolts to support the

slider you are about to put into place on the Jeep

REAR FRONT

1 2 3 4

Installation Instruction RSEI 109 JK4 SLIDER INSTALLATION SL-4D-100-JK SLIDER INSTALLATION 1. Remove the stock rocker guards if equipped 2. R

Installation Instruction RSEI 109 4. Replace the front body bolts on the driver and passenger sides with the 130mm bolt, aluminum spacer, and large

Installation Instruction RSEI 109 b. If no crimping tool is available, follow these instructions i. Install by using a 5/16’’x1.125’’ minimum length

Installation Instruction RSEI 109 12. Double check all bolts to verify components and hardware are installed correctly and securely to the Jeep ***Pl

Sem comentários

Rock-slide-engineering JK4 SLIDER Manual do Utilizador