Rock-slide-engineering JK2 SLIDER Manual do Utilizador descarregar pdf

JK2 SLIDER INSTALLATION

SL-2D-100-JK

Slider Installation

1. Remove the stock rocker guard if equipped.

2. Hold the slider temporarily into the position you would like it on the Jeep.

a. You may want some help so that you can support the weight of the slider

3. Make sure the slider is in the position desired and ensure it will not interfere with

front or rear wheel wells.

4. When the slider is in the desired position, carefully mark the 6 holes on the side of the

Jeep that will be required for mounting the slider.

a. **It is extremely important these holes are marked precisely to insure the

slider will fit properly once the nutserts have been installed

b. Double check to make sure the top side of the slider is at flat 90 degree angle

5. Remove the slider and drill a 7/16” pilot hole in the marked locations.

1 2 3

JK2 SLIDER INSTALLATION SL-2D-100-JK Slider Installation 1. Remove the stock rocker guard if equipped. 2. Hold the slider temporarily into the

6. From the center of the pilot hole, step up the hole size using a 17/32” bit to create a finish hole that will be used to install the nutserts. 7.

13. Double check all bolts to verify components and hardware of secured correctly and securely to the Jeep. ***Please note: Expect some vari

Sem comentários

Rock-slide-engineering JK2 SLIDER Manual do Utilizador